Home > Products > Radio Controlled products > Wing & Micro Servo

Wing & Micro Servo

HIGH VOLTAGE SERVO SERIES Dimensions:29×11×30mm Weight:22g Voltage Range:6.0V - 8.5V
DS189HV
No.02159
  • Torque:4.3(7.4V) / 3.5(6.0V) kg·cm
  • Speed:0.16(7.4V) / 0.20(6.0V) sec/60°
  • For Wing
DS359HV
No.02160
  • Torque:4.3(7.4V) / 3.5(6.0V) kg·cm
  • Speed:0.16(7.4V) / 0.20(6.0V) sec/60°
  • For Miniature Airplanes and Gliders

DIGITAL FET SERVO SERIES Dimensions:29×11×30mm Weight:22g Reted Voltage:4.8V
DS181
No.02147
  • Torque:4.3(4.8V) kg·cm
  • Speed:0.16(4.8V) sec/60°
  • For Wing
DS351
No.02148
  • Torque:4.3(4.8V) kg·cm
  • Speed:0.16(4.8V) sec/60°
  • For Miniature Airplanes and Gliders


If used on a large control surface - typically aileron, rudder, elevator or flap on an airplane, Digital servos (DS・MP・MPH series) may move slightly around center while on the ground. This is an expected phenomenon, and will not occur in the air.
2011 F3K World Champion Joe Wurts talks about DS181!
I was very lucky to receive a few of the new DS181 servos to use in my new Maxa F3J aircraft. On the bench, I was impressed with the accuracy and resolution of the servos. After installation, the control surfaces were tighter than I have ever had before.
The response and accuracy is excellent, I am planning on using them for all future F3B and F3J aircraft.